Application Information - Aircast Cryo/Cuff IC Mode D'emploi

APPLICATION INFORmATION

EN
A P P L I C A T I O N I N F O R m A T I O N
1. B e for e a ppl y i ng t h e Cr yo/Cuf f,
p repare the coo l e r ( Fi gur e 1 )
• Connect the blue tube to cooler.
• Add cold water to line inside cooler.
• Fill with ice.
• Lay insulation disk on top of ice. Attach cooler lid snugly.
• Allow five minutes with occasional shaking to chill water.
2 . A lw ays ap pl y EM PT Y C r y o/Cuff
( Figure 2)
• Use only Aircast Cryo/Cuffs and ArcticFlow Cuffs with
Aircast Cryo/Cuff IC Unit. Cuff is the Applied Part.
• Carefully and completely read instructions supplied with
the specific Cryo/Cuff prior to application. Please follow
the instructions below to continue cooler preparation.
3. F i ll an d pr ess ur i ze C r y o /Cuff
( Figure 3)
• To fill cuff: Connect blue tube to the cuff. Raise cooler no
more than 15" (38cm) above the cuff for approximately 30
seconds while Cryo/Cuff fills.
• To correctly position cooler: Place cooler on stable surface.
The cooler base should be even with the cuff.
NOTE: To AVOID excessive pressure during use, DO NOT
raise the cooler higher than 15" (38 cm) above the Cryo/
Cuff.
• To turn cooler on: Plug power supply into wall outlet and
connect cord to lid.
• To turn off the equipment disconnect the power supply.
• To refill cooler: When Ice has melted , unplug the cooler
and repeat items 1-5 under Step 1.
• For specific cuffs, please refer to instructions for
installation of each cuff and follow procedure above.
4
Figure 1
Figure 2
Figure 3