General DBAR880 Manuel Du Propriétaire page 3

DBAR880 MANUAL-FINAL-91307 9/13/07 4:28 PM Page 3
50 meters high and it is built on a hill which is 50 meters above sea level.
Press "BARO" to confirm & exit.
The barometer will display sea level pressure after the offset.
To select mb/hPa and inHg, press " " button. Altitude will be displayed in feet if
inHg is selected.
PRESSURE HISTORY
The unit will display the moving pressure history of the past 12 hours, providing a
clear & detail picture for pressure tendency.
WEATHER FORECAST
The unit predicts weather condition of the next 12 – 24 hours based on the change
of atmospheric pressure. The coverage area is around 30 – 50 km. The weather
forecast is based on atmospheric pressure change and is about 70-75% correct.
As weather conditions cannot be 100% correctly forecasted, we cannot be
responsible for any loss caused by an incorrect forecast.
SUNNY SLIGHTLY CLOUDY CLOUDY RAINY STORMY
CLOCK & CALENDAR SETTING
Hold "SET" button for 3 seconds to enter clock set. Using " + , - " to adjust and
"SET" to confirm, the following values can be set in sequence:
Year > Month > Date > Hr > Min > 12/ 24 hr > Time > confirm & exit.
ALARM SETTING
To set the alarm time, hold "AL" button for 3 seconds. Press " +, - " to enter the
desired Hr/ Min values and press "AL" to confirm setting.
To view alarm time, press "AL" button at normal mode. Alarm time will display for
5 seconds and resume to normal clock thereafter.
To turn alarm off, press " + " button at normal mode.
SNOOZE/LIGHT
Press "Zz" to trigger a 8-minutes snooze alarm. To stop alarm for one day, press
"AL" button. At normal mode, press "Zz" for an extended backlight.
MEM MEMORY
Press the "MEM" to view the maximum values (In/ Out Temp and Humidity) for
5 seconds, press again to view the minimum memory. The memory will be clear
automatically at 0:00 every day.
Temperature Trend Indicator: The icons will indicate Rising, Steady, Falling if the
outdoor temperature change is more than 1 degree within an hour.
LOW BATTERY INDICATION
Low battery indication is available for the all of the 3 remote channels. Replace the
batteries and follow the setup procedure as mentioned in this instruction manual.