Inova IDESK 61 GRIGIO Notice page 23

Troubleshooting
1. HOT
Issue: Operation of the control box, continuously, for more than 2 minutes.
Solution: a. Wait 18 minutes. b. Disconnect the power cable, wait a few minutes, and then plug
the cable to the power source. The error code will disappear.
2. E01 and E02
Issue:
a. One of the control box cables is not connected properly, it isdefective or broken;
b. The weight on one side of the desk is exceeds 120 kg.
Solution:
Make sure all connection cables are properly connected.
Then wait 3 seconds and the error code will disappear. If the problem still persists, replace the
engine with a new one.
Remove load from desk, then the error code will automatically disappear.
3. E06
Issue: The difference between the two lifting columns is higher than 1 cm.
Solution: start the ''RESET'' process. (RES)
4. E07
Issue: The load weight exceeds the limit of 120 kgs.
Solution: Remove some from the things on the desk .
5. E08
Issue: The input voltage is lower than the required value.
Solution: The error code will automatically disappear when the voltage increases and reaches
the limits required by the device.
6. E09
Issue: The input voltage is too high and exceeds the maximum allowed value.
Solution: The error code will disappear automatically when the voltage decreases and reaches
the maximum value that the device can support.
7. E10
Issue: The control panel is connected or does not receive power, while the control box is
already connected to a power source.
Solution: Wait 1 second, the error code will disappear automatically. If the problem persists,
chack the connection cables.
-8-