Table des Matières
Publicité
ASSEMBLY
Your pressure washer requires some assembly and is ready for use
after it has been properly serviced with the recommended oil and
fuel. We reccomend SAE 10W30 Oil for engines.
If you have any problems with the assembly of your pressure washer,
please call our support line. If calling for assistance, please have the
model and serial number from the data tag available.
Unpack the Pressure Washer
1. Remove the parts bag, accessories, and inserts included with
pressure washer.
2. Open box completely by cutting each corner from top to bottom.
3. Ensure all contents are present prior to assembly.
Attach Handle
1. Place handle (A) onto handle supports (B) connected to main unit.
Make sure holes (C) in handle align with holes on handle supports.
C
NOTE: These diagrams are intended for general reference. As a result,
they may not fully reflect the appearance of your product.
2. Insert carriage bolts through holes from outside of unit and
attach a plastic knob from inside of unit. Tighten by hand.
3. Insert multi-colored quick connect spray tips and other supplied
accessories in spaces provided on handle.
18
A
B
PRE-OPERATION CHECKLIST
Follow the steps below prior to using the machine every time.
1. Check to ensure the engine oil is at the proper level.
Use SAE 10W30 Oil
2. Check the 2 handle knobs in the frame to ensure they are tight and
will not vibrate loose.
3. Add fuel to the gas tank. Be careful not to spill while filling and
do not overfill. We reccomend using fuel with the lowest amount of
ethanol possible. 84 octane and up is suitable.
4. Connect and tighten the garden hose to the GHA (garden hose inlet)
connection.
5. Connect high pressure hose to the pump outlet. Connect the other
end to the spray gun.
** Water must be turned on prior to starting the washer, pull the
spray trigger to ensure water is moving the through the lines and out
the nozzle without any leaks before starting the unit.**
6. Review the safety guidelines in the manual prior to starting the unit.
If you have any issues operating the pressure washer, call our customer
service line.
WARNING
Always check the level of the engine oil prior to starting the
washer. Level should be at about halfway up the sightglass.
If your unit does not have one, use the oil dipstick. The level
should be about halfway up the dipstick.
• Failure to do so could cause the engine to seize if the oil is low or
empty.
Connect Hose and Water Supply to Pump Before Starting
WARNING
DO NOT start your pressure washer without the water
supply turned on.
• Failure to do so will result in damaging the pump from overheating
and void the warranty.
19
Publicité
Table des Matières
