Greenlee SITE-RITE Manuel D'instructions page 5

Back-to-Back 90° Stubs
1. Make the first 90° stub.
2. Fit the bent conduit into its final position and mark the Finish
Line on the conduit, as shown. The Finish Line on the conduit
is the bending mark.
3. Align the bending mark with the tip of the star and bend the
conduit to 90°.
Offset Bends
An offset is used to re-route the conduit to avoid an obstruction.
An offset consists of two equal opposing bends.
Two factors must be considered when selecting the offset angle.
First, a steeper bend angle will require more pulling force. Second,
a shallower bend angle will require more space.
Offset Angle
10° x 10°
22-1/2° x 22-1/2°
30 ° x 30°
45° x 45°
60° x 60°
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
Site-Rite
®
Greenlee
(applies to any size conduit)
Multiplier
6.0
2.6
2.0
1.4
1.2
®
/ Site-Rite II
Offset Table
Shrink Per Inch
®
of Offset Depth
1/16" per inch
3/16" per inch
1/4" per inch
3/8" per inch
1/2" per inch
5