Fagor BV-1000X Manuel D'utilisation page 13

be connected if the accessories are
correctly fitted to the unit.
• Make sure the dial (8) is turned to OFF.
Unwind the cable from the base and
plug in the blender.
• Open the lid (2) or the dispenser cap (1)
by turning them clockwise and pour the
food or drink for blending into the jug.
• Tightly close the lid (fig. F) and fit the
dispenser cap, turning it anti-clockwise
(fig. G).
FUNCTIONING
Switch on the blender by turning the
selector (8) to ON.
There are options for adjusting the rotation
speed or for quick selection, depending on
your needs:
• Speed controller: Select the speed by
turning the selector (8) between MIN and
MAX, if you wish to control the speed
yourself.
• Quick selection: Press one of the three
quick selection buttons, according to
your requirements. The corresponding
pilot light will come on and the appliance
will start to run.
- "Ice" (10.a): this function is
recommended for crushing ice.
The blender runs intermittently for 2
minutes. If you wish to stop it before
this time, press the button again.
- "Smoothie" (10.b): this function
is recommended for making milk
shakes, fine purées, etc., and it runs
for 2 minutes.
If you wish to stop it before this time,
press the button again.
- "Pulse" (10.c): To blend with short
pulses, press this button, release it
and press it again until you obtain the
desired mixture. This function can be
used for cleaning the jug. To do this,
pour some water and a little cleaning
product into the jug.
When you have finished, switch off the
blender by turning the dial (8) to OFF, and
unplug it. To pour out the contents of the
jug, remove the lid (2) (together with the
dispenser cap) from the jug and remove
the jug (3) from the motor base (7) before
pouring out the contents of the jug.
Then clean the blender.
5. CLEANING
• The appliance should be cleaned
immediately after use.
• You may clean the glass jug
automatically. Pour some water and
a little liquid soap into the jug and
press the "Pulse" button. The jug will
automatically self-clean.
• Dismantle the blender by following the
assembly instructions in reverse order
(see the "Assembly" section).
• Clean all the removable components in
warm soapy water and dry them.
• Clean the motor base with a dry cloth.
Do not submerge the motor base in
water or in any other liquid, and do not
place it under the tap.
6. INFORMATION FOR THE CORRECT
DISPOSAL OF ELECTRICAL AND
ELECTRONIC APPLIANCES
At the end of its working
life, the product must not be
disposed of as urban waste.
It must be taken to a special
local authority differentiated
waste collection centre or to
a dealer providing this service. Disposing
of a household appliance separately avoids
possible negative consequences for the
environment and health deriving from
inappropriate disposal and enables the
constituent materials to be recovered to
obtain significant savings in energy and
resources.
To remind you that you must collaborate
with a selective collection scheme, the
symbol shown appears on the product
warning you not to dispose of it in
traditional refuse containers.
For further information, contact your local
authority or the shop where you bought the
product.
11