Cleaning And Maintenance - Sonia Poli Exfo Mode D'emploi

● Press [POWER] on the control panel to turn off the
device. The selected language will be memorised.
● Press the [POWER] button on the control panel. On
the display screen and parameter control:
- The timer will show 15 minutes.
- The power indicator will show 1.
- The continuous wave indicator
- The pause indicator
screen.
● Set the timer using the
the operating time of the machine, in a range of
between 1 and 30 minutes.
● Set the power using the
the power of the machine, in a range of between 1
and 9.
● Selection of wave type: press
wave type.
- When is displayed, the selected wave type
is continuous.
- When
is displayed, the selected wave type
is discontinuous.
- When is displayed, the selected wave type
is pulse wave.
● Use the
button or press on the display screen
to start or stop the device.
- When in operation, an animation will be shown on
the display screen.
- When it is paused or on standby, the animation
will stop and the
display screen.
● To change the previously memorised language when
starting the device for the first time, disconnect
the power cable and wait for 10 seconds. After
reconnecting, the language selection menu will
appear again.
OPERATION
● Connect the device and leave it in standby mode
with the indicator lit.
● Soften the skin in the area to be treated using a
sprayer or clean water.
● The patient should hold the wristband with their
hand.
● Select the type of wave to be used, the operating
time and set the power to minimum.
● Press
or tap on the display screen. An
animation will automatically be shown on the
display screen and the device will start up.
● Then gradually set the power to the level required
for the treatment.
4
will light up.
will appear on the display
or buttons to choose
or buttons to choose
to select the
indicator will appear on the
Bear in mind:
● If the value displayed in the timer is flashing, it
means that the circuit is not closed. The patient
should hold the wristband for the device to operate
correctly.
● Do not use the skin scraper spatula for a long time,
especially in the case of sensitive skin.
● Control the force you use with the spatula when
scraping. Use at a 45-degree angle to the skin.
● Remember to keep applying product to the skin
to keep it moisturised while performing a surface
massage.

CLEANING AND MAINTENANCE

● Before cleaning the device, unplug it from the
mains.
● Clean the device with a soft, dry cloth. Do not use
liquids to clean it.
● After each use, the various components and
accessories must be sterilised and left to dry.
● For maintenance or repairs of any part of the
product, please contact your distributor or
specialised technician.
RECYCLING
If you need to dispose of the product or any of its
parts or accessories, please check and respect the
laws and regulations applicable to waste management
and environmental protection.