Using White Wash; Returning To Default Settings - HP PL5072N Guide De L'utilisateur

The input labels that you can assign are:
Default (original input label)
■
AVR
■
DVD
■
PVR
■
Cable
■
DEC
■
Aux
■
SAT
■
VCR
■
To change an input label by using the remote control:
1
Press the Menu button to open the OSD. The
available menus appear as a list.
2
Press the down arrow button to highlight the
Setup menu, and then press the OK button.
3
Press the down arrow button to move within the
menu and highlight the Input Labels option, and
then press OK to move into the option.
4
Press the down arrow button to highlight the input
source that you want to change, and then press
the right arrow button. Press the down arrow
button to select the new label, and then press OK
to enter the change.
5
When you are finished, press the Menu button to
close the OSD.
42
HP HDTV User's Guide

Using White Wash

In the White Wash menu, select Start, and then press
the OK button to display an all-white screen for three
minutes. This can reduce the appearance of an
afterimage that results from a fixed screen image.
Extensive use of White Wash may reduce
the lifetime of the panel.

Returning to Default Settings

You can use the Default Settings menu to return all
settings, including the input labels, to the default value.
Select Default Settings, and then press the OK
button.
This option does not reset the channels in the Fav and
the channel list. These items are cleared only when you
run a new channel scan.
n