fortress EVOLVER Instructions D'installation page 8

Fig. 2
Max. Post Base Spacing is 73" [1860mm ] .
Fence Board Width is 70-1/2" [1791mm].
Fig. 3
Step 2: Mount Post (Not Embedded/Existing Foundation)
1. Slide the Post over the mounted Post Bases.
As shown in Fig. 1.
2. Be sure to have each fence board slot facing the slot of
the opposite post. As shown in Fig. 2.
3. Use a level to confirm that the post is mounted at
90 degree angle.
o
4. Pre-drill screw holes into Post Base & Post with
a 1/16" [2mm] drill bit.
5. Use a drill to fasten screws into the post to the mounted
post base. As shown in Fig. 3.
Note:
• Closed wall sides are aesthetically best position for forward
facing posts.
• Post Slide Covers can be used to cover unused fence slots.
8
TOP VIEW
SECTION
VIEW
Slide your post over
FENCING INSTALLATION: EVOLVER
Line Post Base
Corner Post Base
STEP 2.1