Peg-Perego gt4 Notice D'emploi page 14

CARRYING ELEMENTS
FASTENED TO IT.
_ IMPORTANT: USE SET
UP AS SHOWN IN THIS
INSTRUCTION MANUAL.
_ THE MANUFACTURER
WILL NOT BE HELD
LIABLE FOR IMPROPER
USE OF THE ARTICLE
_ WARNING Do not use
accessories which are
not approved by the
manufacturer.
_ The footrest may only be
raised when the seat faces
out from the frame.
INSTRUCTIONS
1 REMOVING THE GANCIOMATIC BASE:
Simultaneously press the safety button and
turn the knob in the direction of the arrow
(fig_a). The safety button indicator will
be red (fig_b). Remove the base from the
frame (fig_c).
2 ASSEMBLING: The adapter is composed of a
lower Ganciomatic base (fig_a) and an upper
Ganciomatic base (fig_b). To assemble the
two bases, press the button underneath the
tube on the lower base (fig_c) and hook it
until it locks into place (fig_d).
3 HOOKING IN PLACE: Point the adapter as
shown.Position the connections for the
upper base on the chassis housings (fig_a)
and push downwards until they lock into
place (fig_b).
4 Hook the lower base of the adapter to the
chassis (fig_a) and push until it locks into
place (fig_b).
5 HOOKING ON THE FOOTREST: Pull off
the fabric cover on the seat footrest and
raise the footrest (fig_a) and position the
footrest on the seat footrest (fig_b).
6 Insert the footrest and hook it in place,
until it locks into place, checking that it is
hooked into place correctly and appears
as shown in the figure (fig_a - fig_b). To
remove it, release the footrest at the rear,
and then simultaneously lift and pull it out
from the front (fig_c).
WARNING: Only use the footrest with the
seat in the lower forward-facing position.
7 REMOVAL: To remove the adapter from the
chassis, raise the base at the front (fig_a)
and pull on both buttons (fig_b) to release
it (fig_c).
8 Press the connection buttons (fig_a) and
raise the adapter to remove it (fig_b).
9 FOLD: To fold the frame with the adapter
fastened in place, remove the carrying
elements and fully lower the handle bar.
Press the central safety lever with your
thumb (fig_a), grasp and lift the lock
handle (fig-.b) to rotate the handle bar
forward until fully locked (fig_c).
10 To correctly lock, make sure the side hooks
are fully closed.
11 SECURING THE GANCIOMATIC BASE: To
secure the base, make sure the indicator is
red. Correctly place the base on the frame
(fig_a) with the hooks under the lock pins
(fig_b). Turn the knob in the direction of
the arrow until it clicks, the safety indicator
turns green (fig_c).
IMPORTANT: Lift the base up to ensure it
is correctly fastened.
12 ATTENTION: Do not touch the fastening
knob on the Ganciomatic base unless
required by specific instructions.
Check that the base is correctly secured
to the frame by making sure the arrows
are positioned as illustrated and that
the indicator is green.
IMPORTANT: Lift the base up to ensure it
is correctly fastened. Otherwise, secure
the Ganciomatic base.
GANCIOMATIC SYSTEM
Ganciomatic is a fast and practical system
that allows you to attach the pram body,
the car seat and the seat to the Ganciomatic
base of the chassis in one quick step.
COMBINATION
WARNING:
14
The second seat must be