Advanced Operation - Astralpool BM100 Manuel D'instructions

TECHNICAL MANUAL. START-UP AND OPERATION
Press the key "set" for at least 2 seconds, then enter the state of temperature setting, here the LED displays the setting temperature, then
using "" key or "" key can change the parameter (the key "" adds 0.1°C, the key "" minuses 0.1°C, press and hold it over
0.5 seconds can add or minus rapidly). After setting, press "set" again, then exit the state of parameter setting. (The setting temp range is
limited by the parameters F13 and F14; please refer to the senior operation). Pressing the key "M" in the setting process means cancel and
exit, but the setting value will not be saved.
When displaying current temperature, press "" key, Controller will display defrosting temperature. Loose "" key, then return to current
temperature.

Advanced Operation

Press the key "M" and hold it for
you can use the key "" and "" to enter the password, if the password is correct, the LED will display the parameter code, use ""
or "" to select the parameter code. Pressing the "set" key can make it to show the value of the parameter after select the
parameter, here you use "" or "" to set the parameter (pressing the key and not release can add or minus rapidly), then press
the "set" key to return to the state of showing parameter code after finishing setting. Pressing the key "M" can exit the parameter setting
state when display the parameter code, pressing the key "M" means cancel when in the process of setting parameter, and the parameter will
not be changed.
Internal parameter code is showing bellow:
Sort Code
F11 Setting temperature
F12 Temperature difference
F13 Max setting temperature
Temperature
F14 Min setting temperature
Auto mode temperature
F17
difference
Evaporator sensor
F18
adjustment
F19 Temp sensor adjustment
F21 Compressor delay time
Compressor controlling
Compressor
F29 mode (temp controlling
F31 Defrost start temperature
F32 Defrost end temperature
F33 Defrost start time
Defrosting
F34 Max defrost time
F37 Defrost mode
18
How to set the temperature?
How to read the temperature of the evaporator sensor?
5
seconds, and if you have set the password, the LED display the "PAS" to hint you to enter the password,
Parameter Name
F14 – F13
0.1 – 20
-58 - 302
-58 – 302
-20 – 20
-20 – 20
COOL / HEAT
mode)
-20 – 80
0 – 100
Off, 1 – 99
Range Factory setting
28
1.0
35
10
3 - 20 3
0.0
0.0
0 -- 10 3
HEAT
/C/H
-2 / -1 / 0
10 / 20
1 – 999 5 / 10
10
0 - 1 0 / 1
℃/℉
Unit Remark
The setting range is limited
by F13 and F14
℃/℉
Control the temperature
difference, please refer to the
℃/℉
temperature controlling
Notice: the controller will
follow the rule of
F14<F11<F13 forciB, if you
℃/℉
find out that one parameter
can not be adjusted, it is
because the parameter is
limited by other parameters,
you must first adjust other
℃/℉
parameters
If F17<F12,F17=F12
℃/℉
admited
Adjust the outdoor machine
℃/℉
sensor bias
Adjust the temperature
sensor bias
min
COOL: refrigeration mode
- HEAT: Heat mode
℃/℉
C/H :Auto mode
℃/℉
Depends on the model
Depends on the model
min Depends on the model
min Off means no defrost
0:air defrost
-
1: 4 way valve defrost