Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Screw Holes
When you install the mainboard, you have to place the mainboard into the chassis in the
correct direction. The locations of screws holes on the mainboard are shown as below.
The side has to toward
the rear, the position
for the I/O shield of the
chassis.
Refer above picture to install standoffs in the appropriate locations on chassis and then
screw through the mainboard screw holes into the standoffs.
Important
To prevent damage to the mainboard, any contact between the mainboard circuit and
•
chassis or unnecessary standoffs mounted on the chassis is prohibited.
•
Please make sure there is no metal components placed on the mainboard or within
the chassis that may cause short circuit of the mainboard.
Screw holes
En-5
Publicité
Table des Matières
