Pioneer SGX-CA500 Guide De Démarrage Rapide page 13

8
Adjust the angle of the device,
and then tighten the bracket.
If the device is not aligned to the center
of the handlebars or not horizontal to
the stem, loosen the bolt and realign
the bracket.
After adjusting the angle, clamp the
temporary joint bolt and tighten the
bracket.
Use a tool that can measure the torque
to tighten the bolts.
• Tightening torque: 1.2 N·m
•
Front view
•
Side view
Installation on Your Bike
To detach the device
To detach the device from the
handlebar mount, press the fixed lever
to the right, a red circle will appear next
to the device when unlocked.
Pull back on the unlock lever on the
bracket and lift the device.
Fixed lever
Unlock lever
EN
13