Charging The Battery Pack - oneConcept 10031395 Mode D'emploi

Charging the Battery Pack

The battery pack is not fully charged at the time of purchase and therefore needs to be
charged before use. If the battery charge becomes low while you are using the scanner, it
is recommended to recharge it as soon as possible.
1. Insert the battery pack into the battery compartment (see page 8)
2. You may charge the battery in 2 ways:
(a) Plug the Micro USB of the supplied USB cable to the USB connector of the scanner, and
plug the other USB end into the USB port of your computer/notebook. Please charge
the battery at least 3 hours prior to your first use.
(b) Connect the Micro USB wire to the Power Adaptor then Plug it to the household power
outlet. Connect the micro USB terminal to the Micro USB connector of the scanner.
The Red LED is lighted during battery charging when the scanner is not in use, and
will be off when it is fully charged.
Please charge the battery at least 3 hours
29