Vehicle Preparation - Can-Am 715 000 635 Instructions

PARTS TO BE INSTALLED
PARTS TO BE INSTALLED
vsi2009-021-001_a
ITEM P/N
P1 705 003 303
P2 705 003 304
P3 250 000 327
P4 705 003 008
P5 233 281 434
P6 236 282 084
INSTRUCTIONS
The following procedure is applicable to the
NOTE:
RH and LH sides unless otherwise noted.

Vehicle Preparation

1. Remove lower retaining screws from front
bumper.
vsi2009-030-009_a
1. Lower retaining screws
2. Remove upper retaining bolts and nuts from
front bumper.
2 / 4
DESCRIPTION QTY
LH Lower Bumper
Extension
RH Lower Bumper
Extension
M8 x 75 screw
Sleeve
M8 nut
M8 x 20 bolt
vsi2009-030-010_a
1. Upper retaining bolt
3. Remove front bumper from vehicle.
Bumper Extension Installation
1
1. Place front bumper on a workbench.
2. Remove plastic covers from front bumper us-
1
ing side screws.
2
2
2
2
vsi2009-030-008_a
1. Plastic cover
2. Front bumper
3. Side screws location
3. Install bumper extension on front bumper.
4. Install M8 x 20 bolts on upper holes.
5. Tighten M8 nuts on upper holes.