Technical Manual; Safety Instructions - Dictator 50 BK-Z Manuel Technique

1) Safety Instructions

2) Components Included
(Ill. 1)
© DICTATOR Technik GmbH • Gutenbergstr. 9 • 86356 Neusäß • Germany
Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail info@dictator.de • 201812
A) Safety Instructions / Components Included
When installing and using the DICTAMAT 50 BK-Z with revolving toothed
belt make sure to observe all information and advice of this manual.
During installation we recommend to wear protective gloves to prevent
any risk of getting hurt by sheet edges.
The casing of the spring rope pulley may never be opened as the released
spring can cause major injuries. If the spring rope pulley should for some
reason no longer work properly, the complete device has to be replaced!
It has also to be assured that the spring rope pulley, the radial damper
and the idler pulley are protected in order to prevent fingers being
trapped (protection cover!).
The closing speed has to be adjusted at the radial damper so that the
door can easily be stopped by hand in every position, making sure
nobody will be endangered.
Spring rope pulley (closing force 25 N, 50 N or 80 N) with bracket
and 2 m of plastic rope
Radial damper with fixing brackets, toothed belt disk and fixing
accessories
Idler pulley with fixing brackets, pre-assembled
Door actuator with fixing bracket and toothed belt tensioner
Toothed belt, lenght as required
Idler pulley with
LD 50 radial
fixing brackets
damper;
fixing
bracket
Mounting
accessories
Door actuator with toothed
belt tensioner
Revolving toothed
belt

Technical Manual

DICTAMAT 50 BK-Z
Spring rope pulley
with bracket
Ill. 1
Page 02.090.01