Installation - Heartland HCTMR20A Instructions D'utilisation

This Use & Care Guide provides general operating instruc-
tions for your model. Use the refrigerator only as instructed
in this Use & Care Guide. Before starting the refrigerator,
follow these important first steps.
Location
• Choose a place that is near a grounded electrical out-
let. Do Not use an extension cord or an adapter plug.
• If possible, place the refrigerator out of direct sunlight
and away from the range, dishwasher or other heat
sources.
• The refrigerator must be installed on a floor that is level
and strong enough to support a fully loaded refrigerator.
CAUTION
!
Do Not install the refrigerator where the temperature will
drop below 55°F (13°C) or rise above 110°F (43°C). The
compressor will not be able to maintain proper tempera-
tures inside the refrigerator. Do Not block the toe grille on
the lower front of your refrigerator. Sufficient air circulation
is essential for the proper operation of your refrigerator.

Installation

Installation clearances
• Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical con-
nections:
Sides & Top ⅜ inch
Back 1 inch
NOTE
If your refrigerator is placed with the door hinge side
against a wall, you may have to allow additional space so
the door can be opened wider.
Guidelines for final positioning of your refrig-
erator:
• All four corners of the cabinet must rest firmly on the
floor.
• The cabinet should be level at the front and rear.
• The sides should tilt ¼-inch (6 mm) from front-to-back
(to ensure that doors close and seal properly).
• Doors should align with each other and be level.
INSTALLATION
To install the toe grille:
1. Attach toe grille support bracket to cabinet using 3 bolts
supplied.
2. Install left toe grille cover onto slot on left side of toe
grille.
3. Attach toe grille to cabinet.
6