Heartland HCTMR20A Instructions D'utilisation page 12

Part
Interior and door liners
Door gaskets
Drawers and bins
Toe grille
Glass shelves
Exterior and handles
Exterior and handles
(Stainless steel models)
Replacing light bulbs
CARE AND CLEANING
Care and Cleaning Tips
What To Use
• Soap and water
• Baking soda and water
• Soap and water
• Soap and water
• Soap and water
• Mild liquid sprays
• Vacuum attachment
• Soap and water
• Glass cleaner
• Mild liquid sprays
• Soap and water
• Non abrasive glass cleaner
• Soap and water
• Stainless steel cleaners
• Unplug refrigerator
• Wear gloves
• Remove light cover
• Replace old bulb
• Replace light cover
• Plug in refrigerator
Tips and Precautions
Use 2 tablespoons of baking soda in 1 quart of water. Be
sure to wring excess water out of sponge or cloth before
cleaning around controls, light bulb or any electrical part.
Wipe gaskets with a clean soft cloth
Use a soft cloth to clean drawer runners and tracks
Vacuum dust from front of toe grille. Remove toe grille
(see Installation Instructions). Vacuum backside, wipe with
sudsy cloth or sponge. Rinse and dry.
Allow glass to warm to room temperature before immers-
ing in warm water.
Do not use commercial household cleaners containing
ammonia, bleach or alcohol to clean handles. Use a soft
cloth to clean smooth handles. DO NOT use a dry cloth to
clean smooth doors.
Never use CHLORIDE or cleaners with bleach to clean
stainless steel.
Clean stainless steel front and handles with nonabrasive
soapy water and a dishcloth. Rinse with clean water and
a soft cloth. Use a non-abrasive stainless steel cleaner.
These cleaners can be purchased at most home improve-
ment or major department stores. Always follow manufac-
turer's
instructions. Do not use household cleaners containing
ammonia or bleach.
NOTE: Always clean, wipe and dry with the grain to pre-
vent scratching. Wash the rest of the cabinet with warm
water and mild liquid detergent. Rinse
well, and wipe dry with a clean soft cloth.
CAUTION: Wear gloves when replacing light bulbs to
avoid getting cut. Use same wattage when replacing bulb
12