Safety Instructions; Technical Data - Meec tools 013933 Mode D'emploi

EN

SAFETY INSTRUCTIONS

• Always check the product before use.
• The product must only be operated and
loads lifted or lowered when the user has
full supervision of the product and the
work area.
• Check that all welded joints are free from
cracks and that all bolted joints are
correctly tightened.
• Check that the level of the hydraulic fluid
is correct and that there is no leakage.
• Only use the product on a level, hard
surface and ensure that it is free to roll
during lifting and lowering.
• Lower the load to the lowest possible
position before moving the product.
• Be very careful when moving the product
with a lifted load. Make sure that the load
cannot start to swing out of control.
• Never work under a load hanging only
from the product. Make sure that an
uplifted engine is correctly mounted on a
suitable stand or on all the brackets in the
vehicle.
• Do not overload the product. Always
observe the permitted maximum load in
each given arm position.
• Lower the load slowly and carefully.
• Failure to follow all the instructions and
safety instructions can lead to the risk of
serious personal injury and/or material
damage. It will also invalidate the warranty.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
22

TECHNICAL DATA

Lifting height*
Length**
Max capacity
Number of lifting positions
Swivel lifting hook
Size folded
Size
Weight
* for 250 kg. ** with unfolded support legs.
THE WORKSHOP CRANE WORKS AT
THE FOLLOWING HEIGHTS
0,25 T Min : 160 mm, Max 2040 mm
0,5 T Min : 245 mm, Max 1980 mm
0,75 T Min : 330 mm, Max 1920 mm
1 T Min : 415 mm, Max 1860 mm
DESCRIPTION
Hydraulic workshop crane with swivel lifting
hook and retractable lifting arm with four
alternative lifting positions (max 250, 500,
750 and 1000 kg). The crane has six wheels for
greater stability and safety, and is foldable for
easier storage.
FIG. 1
ASSEMBLY
NOTE:
Two persons are required for assembly.
• Study the supplied assembly details
before assembly. Dimensions and number
are specified in the list of assembly parts.
Check that all the parts and assembly
parts are included.
• Assemble the product from the lowest
parts and up.
• Assemble the product on a level surface,
otherwise the assembled product can be
skew and result in a risk of personal injury
160 – 2040 mm
1515 mm
1000 kg
Yes
455 x 180 x 1445 mm
1515 x 1050 x 1445 mm
64,5 kg
4