Use - Ninja BL450 Mode D'emploi

Use

ASSEMBLY
Fig. 1
IMPORTANT: Make sure that the motor base is
plugged in for use.
1 Place the motor base on a clean, dry, level surface
such as a counter or table top.
2 Add ingredients to the cup.
3 Place the blade onto the cup and twist it on tightly
until you have a good seal. (Fig. 1)
4 Turn the cup upside down and place it onto the
motor base, aligning the tabs on the cup with the
motor base. Turn it clockwise, the unit is ready for
use.(Fig. 2)
5 Press down on the top of the cup in short intervals
to activate. (Fig. 3)
PULSE
Fig. 2
For best results, use short "PULSES"!
Fig. 3
6 When you have reached your desired consistency,
stop the appliance by removing your hand from the
cup. Wait for the motor to stop running. Then turn
the cup counterclockwise (Fig. 4) and pull straight
up to remove. (Fig. 5)
NOTE: Do not overfill! To avoid spilling, do not
add ingredients past the "Max" fill line.
7 Turn the cup upright and remove the Blade
Assembly by twisting the blade assembly
counterclockwise. Be sure to store the Blade
Assembly attached to an empty cup when not in
use.
8 Place the Sip & Seal
and enjoy!
9 Make sure that the motor base is unplugged when
not in use.
REMOVAL
Fig. 4 Fig. 5
lid onto the cup, twist to seal
™
www.ninjakitchen.com
13