Stid MS2 Manuel D'utilisation page 2

OEM Module
MS2 13.56 MHz
MS2S 13.56 MHz & Blue
Installation instructions
Available Baud rate
Factory Baud rate
Mode
Number of bits
Transfer mode
Stop bit
0.16
0.11
General tolerance +/- 0.3%.
1- The module is limited to OEM installation ONLY.
2- The OEM integrator is responsible for ensuring the end user has no manual instructions to remove or install module.
3- The module is limited to installation in mobile or fixed application.
4- The separate approval is required for all other operating configurations, including portable configuration with respect to Part 2.1093 and different antenna
configurations.
5- Labeling instructions of finished (host) product. Note that this label must include both this module's ID and the included module's ID.
STid declares that the MS2-A/MS2S-A reader is compliant to the essential requirements of the Directives RED 2014/53/EU, RoHS 2011/65/EU and Delegated directive.
A copy of our declaration is available on request from qualite@stid.com.
This device complies with part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation
NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such
modifications could void the user's authority to operate the equipment.
This device complies with the safety requirements for RF exposure in accordance with RSS-102 issue 5 for conditions of use and with §1.1307(b),
2.1091 and 2.1093 of the FCC rules Title 47 CFR Ch. I.
The maximum magnetic field level of the device is:
MS2 12.3 dBµA/m (at 10 meters) for 13.56MHz frequency
▪
MS2S 19 dBµA/m (at 10 meters) for 13.56MHz frequency
▪
4 dBm for 2.4 GHz frequency
Integrating the MS2/MS2S module into a finished product will require:
1) Measure the radiation of the finished product and verify that it complies with the applicable standards (FCC Part-15).
2) Perform tests to ensure that the finished product meets all applicable RF exposure requirements (§1.1307(b), 2.1091 and 2.1093
of the FCC rules Title 47 CFR Ch. I).
STid reserves the right to make change without notice, for the purpose of product improvement.
Module OEM
MS2 13,56 MHz
MS2S 13,56 MHz & Blue
Notice d'installation
9600, 19200, 38400, 57600, 115200 bauds
MS2/MS2S R & S: 9600; MS2/MS2S W: 38400 (SSCP®)
0.198
1.73
© STid - 20 PA des Pradeaux FR13850 Gréasque – NI1140A03- Page 2 sur 6 - Ed. 28/06/2021
RS232-TTL communication
Asynchronous
8
LSB first
1
Dimensions (in inch)
2.38
FCC integration requirement
Declaration of compliance
Módulo OEM
MS2 13.56 MHz
MS2S 13.56 MHz & Blue
Procedimiento de instalación
conforme con NOM-024 -SCFI-2013
More details about reader
communication are available
in the protocol specification.
0.39
US
FR
ES
0.1