Scandyna PodSpeakers CinePod Guide De L'utilisateur page 7

ENGLISH /
Connecting your loudspeaker
We recommend that you read the manual of your amplifier or av-receiver carefully before connecting
CinePod. Please switch off all equipment when connecting CinePod.
ENGLISH /
Running-in period
We recommend a running-in period of your new CinePod centre speaker of approximately 15-20 hours at normal listening level before you decide on the final positioning and set-
tings of the loudspeaker. During the running-in period, the drive units will settle in and perform as intended.
ENGLISH /
Care and cleaning
We strongly advise against the use of any solvents or cleaners on the lacquered cabinet. The cabinet surface usually only requires dusting or cleaning with a damp soft cloth (only
use cold clean water). Avoid touching the drive units, as this may damage the loudspeaker.
ENGLISH /
Environmental information
CinePod complies with international directives on the Restriction of Hazardous Substances (RoHS) in electrical and electronic equipment and the disposal of Waste Electrical and
Electronic Equipment (WEEE) - the crossed bin symbol indicates compliance and that the products must be appropriately recycled or processed in accordance with these directives.
The binding posts on the terminal
accepts wire up to Ø 4mm.
Make sure that the positive terminal
binding posts on CinePod (+) are con-
nected to the positive output terminal
binding posts on the amplifier and that
the negative terminals on CinePod (-) are
connected to the negative output
terminal on the amplifier.
You are now ready to enjoy the great
sound of CinePod.
// 7