Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.4
Original STARTBOX settings
- Your
virtually all automatic watches currently available on the
market.
- When you flick the power switch to On, an LED flashes red
and green alternately to indicate the startup phase and the
watch winder detects the vertical position of the watch holder.
- Then the watch undergoes 90 cycles of 20 rotations each (45
cycles clockwise and 45 cycles anticlockwise), a total of 1800
rotations every 24 hours. Between each rotation cycle, the
watch holder stops automatically in its initial vertical position.
3.5
Replacing the batteries
a)
Unscrew the battery cover retainer screw using a small
coin and remove the cover as illustrated in the diagram
below.
b)
Remove the used batteries and insert two new batteries
in the corresponding compartments.
CAUTION: make sure you respect the +/- polarity when
inserting new batteries. Failure to do so could cause
irreversible damage to your watch winder.
c)
Replace the battery cover and screw the retainer screw
back in using a small coin.
watch winder is programmed to rewind
STARTBOX
Publicité
Table des Matières
