Counterfeit Detection - Duramaxx 10020088 Mode D'emploi

Add counting Function
Add counting can be performed by pressing the "ADD" button (when the ADD indicator is on).
In this case, removing the counted bills from the stack, it will not clear the quantity counted
number and shown on the counter display. The next bills placed in the hopper will be coun-
ted and added to the preceding quantity. The total pieces of added bills will be shown on the
counter screen. Press the "ADD" button to close the function and clear the count.
Batch Function
• The preset batch counting function can be performed by pressing the "BATCH" button and
the BATCH indicator is on.
• By default, when pressing the "BATCH" button, the batch number is set to 100. By pres-
sing it again, the batch number can be changed to be 50 the second time, and 20 the
third time.
• The batch number can be setted in the range from 1 to 999 by pressing "+" or "-" button.
• Press the "+" or "-" button for more than 0.25 sec, the number will increase or decrease
by 5 unit one time; while press the "+" or "-" with only a single and fast strokes, it will
increase and decrease 1 by 1.
• To clear this function, press the "BATCH" button until and indicator is off.
• Under the batch counting mode, once the hopper is loaded, the machine will start coun-
ting and stop when the counted quantity reaches the preset batch number.
• To repeat the batch counting operation under the same preset batch quantity, just re-
mover the counted bill from the stacker. The unit will batch the next group of bills under
the same settings.
• If you wish to keep batching without removing the preset number, press the "RESTART"
button.
• If the counted number does not reach with the preset batch number, the counter display
will show the quantity with blinking number.
• When counting with MG and/or UV detection on, the machine will stop automatically
when detecting counterfeit currency. This function can be resumed by removing the sus-
picious bill from the stacker and pressing "RESTART" button.
UV (Ultraviolet) detection function
Used to check all kinds of banknotes which contains UV features. The UV function is auto-
matically turned on by default when the machine is powered up. It can also be selected or
deselected by pressing the UV button located in the function console. If the machine de-
tects a counterfeit note when counting, it will stop and emit beeping sound, while the batch
display will show the Error code "A" and the UV indicator will blink (alerting the user and
presence of a suspicious bill). The suspicious bill will always be the last one on the stacker.
Remove the suspicious bill, press "RESTART" button to continue.
12

Counterfeit Detection