Important; Dismantling And Assembling - KREA Swiss multiSPRAY Mode D'emploi

CLEANING
IMPORTANT: Always remove the electrics and heating unit before washing the
gun. These parts should never be exposed to liquids.
Always clean immediately after use. For external cleaning, simply wipe down the
outside of the sprayer with an approved food grade detergent. For internal cleaning,
if using materials other than light oil, we recommend to spray through half a container
of food safe mild detergent solution and then clean the individual parts. Alternatively,
the plastic components can be placed in the regular 60°C / 140°F dishwasher cycle.
Careful use of a soft pipe cleaning brush is also recommended but care should be
taken not to damage the cylinder by using abrasive or sharp tools. If available,
passing air flow through the nozzle and suction tube can ease the cleaning process.
The sprayer is designed with quality components. If you experience any issue, we
recommend first following the trouble shooting document and films on our
website: www.KreaSwiss.com/professional-food-sprayer-guns. In most cases a part
has been forgotten during post cleaning assembly. If your issue persists please
contact your reseller for additional support, including the article number (Page 3) in
any correspondence.
DISMANTLING AND ASSEMBLING (see page 2-3)
• Remove the round jet nozzle (9) and then unscrew the bent nozzle extension
screw (8) from the pump housing (5).
• Remove the atomiser insert (7) and valve ball (6) from inside the chamber. Place
all parts in a small dish and clean them following the cleaning steps outlined earlier.
The suction tube (10) and container (11) can be washed in the sink.
• Remove the service screw (2) and take off the pump housing (5). Put the
piston (3), piston spring (4), hood (1) to one side and wipe them down as outlined
above.
• Remove the valve ball (6) from the pump housing (5) by using a copper or brass
pin to push it through the piston aperture.
• To assemble the gun, do so in reverse order. The piston should move freely in the
pump housing. Ensure the service screw, nozzle extension and round jet nozzle
pieces are all screwed on tightly.
6