Installation - Warmup 3iE Manuel D'installation

INSTALLATION

4-inch square back box
To install your thermostat on the wall, you'll need a square 4"x4"
back box with a single mud ring (also called plaster ring).
Opening the thermostat
1. Separate the front housing of thermostat as shown on the
2. Unscrew both closing screws (at the bottom) until they don't
3. Release front housing by gripping lower half of outer frame
Placing the back box
1. Open the back box and create openings by pushing one or two
2. Place the rear part into the wall where you've chosen to place
3. With 2 screws, secure the back of the 3iE to the face of the
Connecting wires
1. Attach the sensor wires into the thermostat following the
2. Check to ensure that you have all the following wires
3. Complete wiring as explained on the following pages.
4. Pull wires into the electrical box.
24/7 Technical hotline - Ligne d'assistance technique - Línea de asistencia técnica
US 1.888.927.6333 / CA 1.888.592.7687
picture.
turn any further.
and pulling outwards then upwards. Place front housing
somewhere safe.
holes.
the thermostat.
electrical box (see picture on opposite page).
instructions on page 8.
connected to the back panel of the thermostat:
- Power lead (Line 1 and Line 2 )
- Heater wire (Line 1 and Line 2)
- Floor sensor
- External/ 2nd floor Sensor (if necessary)
5