Summit Appliance AccuCold FCL44 MED Série Mode D'emploi page 10

DIGITAL THERMOSTAT INSTRUCTIONS
If you find that it is necessary to change the temperature setting for your
digital-thermostat controlled appliance, please refer to the following
instructions. The front panel of the thermostat is illustrated here:
To see the SET POINT:
Push and immediately release the SET key. The display will show the SET
POINT value. Wait 5 seconds and the probe value will display again.
To change the SET POINT:
Push and hold the SET key for more than 3 seconds to change the set point
value. The value of the set point will be displayed, and the "snowflake" LED
will start blinking.
To change the SET value:
Push the UP or DOWN arrow to the desired setting. The new setting will be
memorized after 15 seconds, provided no other keys are pushed.
Note:
The minimum and maximum range of your thermostat is preset
and locked by us, so it cannot easily be accidentally moved between
freezer and refrigerator temperatures. To reset this range lock, either
call us or find information on our website under Troubleshooting.
TRACEABLE THERMOMETER / ALARM
monitored, such as inside a refrigerator or freezer, once the unit has been
programmed. The thermometer/alarm itself can be attached to the door of
the unit with the magnet on the back, or it can be placed on a convenient
table or shelf.
Power to the Thermometer/Alarm is supplied with a lithium iron disulfide
battery with a 10-year shelf life. When it is inserted correctly, the unit will
beep and all segments of the LCD display will be temporarily activated.
(Note that alarm temperatures will have to be reset after replacing the
battery.)
The temperature display can be switched between Celsius (°C) and
Fahrenheit (°F) by sliding the
Page 10
Every unit is equipped with a Traceable Thermometer/
Alarm that simultaneously displays minimum, maximum
and current interior temperatures and provides a visual
and audible signal when the temperature inside the unit
falls outside the set temperature range.
The temperature sensor, or probe, is enclosed in a
glycol-filled bottle that you insert into the location to be
button located on the back of the unit.
°C/°F
Felix Storch, Inc.
melting
snowflake
snowflake
UP & DOWN arrows
SET key