Important Safety Notes - BSVILLAGE ROBOTCLEAN ACCU Manuel

1 Robotclean Accu Operating Instructions and Parts List
Dear Customer,
Thank you for choosing our product to clean your pool entirely without cables or connection to the power.
We hope you enjoy your new pool cleaner when looking after your swimming pool in forthcoming years.
Take a few minutes before using your RobotClean Accu for the first time and read the operating instructions carefully.
Scope of delivery
1 Pool RobotClean Accu
1 battery charger
1 pull cord 2.3 m
1 driving handle (red)
2 brushes
1 operating instruction booklet

DO NOT ENTER THE POOL WHEN THE CLEANER IS IN USE
Technical Data
POOL ROBOT CLEAN ACCU
Input Voltage
Protection Class
Protection Type
Immersion Depth
Working Temperature
Storage Temperature
Safety System
Type of Cleaning
Cleaning Area
Cleaning Time
Speed
Filtration Grade
Suction Power
List of Components
Ref.-Nr.
1
2
3
4
5
6
7
8

IMPORTANT SAFETY NOTES

- Take note of all safety notes and instructions stated on the charging adapter and pool cleaner. Non-compliance can result in serious injury or damage to property.
- This appliance is suitable for cleaning water at temperatures between min. 5° C and a maximum of 45° C.
- When charging, the appliance may be connected only to an earthed AC 230 V shockproof socket
(residual current circuit breaker with a rated residual current of no more than 30 mA).
- The power supply for the charging adapter must be at least 3.5 metres away from the pool.
- The pool cleaner must be used only for cleaning private swimming pools. All other usage results in the immediate expiry of the warranty.
- The pool cleaner is not suitable for pools with a membrane thickness under 0.4 mm. The use of the pool cleaner below this film thickness is at your own risk.
- The pool cleaner must not be used when there are people in the pool.
- The insulated drive unit and the charging adapter do not have components, which need servicing. Only expert technicians may open these parts.
The guarantee expires otherwise.
- During the cleaning process some lubricants may leak from the motor oil seal, which might result in slight contamination of the water.
12,6 VAC / 50-60 Hz, 50 Watt, 1.8 A
III
IPX8
max. 2 m
10°C - 35°C
20°C - 45°C
Yes (Overload Protection)
Floor
ca. 50m
2
max. 2 h
approx. 16m/min
100 Micron
approx. 10 m3/h
Description
Side Cover
Floating Handle
Housing - Upper Part
Connecting Rod 1
Swing Flap
Connecting Rod 2
Control Nozzle
Drive Unit
LITHIUM BATTERY/BATTERY CHARGER
Input Voltage
Output Voltage
Battery Capacity
Protection Class
Protection Type
Battery Life
Battery Charging Time
Operating Temperature (Charging Adapter)
Storage Temperature (Charging Adapter)
Ref.-Nr.
9
10
11
12
13
14
15
16
100-240 VAC / 50-60 Hz
12,6 V / 1,8 A
6600 mAh
II
IP20
max. 2 hours
5-6 hours
0°C - 45°C
20°C - 45°C
Description
Safety Screen
Spring
Filter Element
Water Inlet Grid
Housing - Lower Part
Wheel
Brush
Pull Cord