Troubleshooting Guide; Tool Specifications - Porter Cable FR350A Manuel D'instructions

MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART
BELOW. FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A PORTER-
CABLE SERVICE CENTER OR CALL 1 888 848-5175.
To reduce the risk of serious personal injury, ALWAYS disconnect
air from tool before all repairs.
Symptom
Air leak near top of
tool or in trigger area
Tool does nothing or
operates sluggishly
Air leak near
bottom of tool
Tool jams frequently
Other
Height (inch/meter)
Width (inch/meter)
length (inch/meter)
Weight (lbs/kg)
recommended operating pressure 70-120 psi (4.8 to 8.3 bar)
Air Consumption per 100 cycles
loading capacity

trouBleSHootInG GuIDe

proBlemS
Loose screws.
Worn or damaged
o-rings or seals.
Inadequate air supply.
Inadequate lubrication.
Worn or damaged
o-rings or seals.
Loose screws.
Worn or damaged
o-rings or bumper.
Incorrect fasteners.
Damaged fasteners.
Magazine or nose screws loose Tighten screws.
Magazine is dirty.
Driver tip is worn or
damaged.

tool SpecIfIcatIonS

15 - ENG
SolutIonS
Tighten screws.
Install Overhaul Kit.
Verify adequate air supply.
Put 5 or 7 drops of
oil into air inlet.
Install Overhaul Kit.
Tighten screws.
Install Overhaul Kit.
Verify approved fasteners
of correct size.
Replace with undamaged
fasteners.
Clean magazine.
Install Driver Maintenance Kit.
Contact a PORTER-
CABLE Authorized
Warranty Service Center
FR350A
13.8/0.35
4.6/0.15
21.2/0.54
7.7/3.5
9.76 SCF
63–64 nails