Important - Beper Pro Mix Manuel D'instructions

Hand Blender with Cup Use instructions

Important

Read this user manual carefully before you use the appliance and save it for future reference.
Danger
-- Never immerse the motor unit in water or any other liquid, nor rinse it under the tap. Only use a
moist cloth to clean the motor unit.
Warning
-- Check if the voltage indicated on the appliance corresponds to the local mains voltage before you
connect the appliance.
-- Do not use the appliance if the plug, the mains cord or other parts are damaged.
-- If the mains cord is damaged, you must have it replaced by Beper, a service centre authorised by
Beper or similarly qualified persons in order to avoid a hazard.
-- If the appliance is damaged, always have it replaced with one of the original type, otherwise your
guarantee is no longer valid.
-- This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
-- Children should be supervised to ensure that they do not play with the appliance.
-- Do not touch the blades, especially when the appliance is plugged in. The blades are very sharp.
-- If the blades get stuck, unplug the appliance before you remove the ingredients that block the
blades.
Caution
-- Switch off the appliance and disconnect it from the mains if you leave it unattended and before you
assemble, disassemble and clean it.
-- Never use any accessories or parts from other manufacturers or that Beper does not specifically
recommend. If you use such accessories or parts, your guarantee becomes invalid.
-- This appliance is intended for household use only.
-- Do not exceed the quantities and processing times indicated in the tables.
-- Do not process more than 1 batch without interruption. Let the appliance cool down for 5 minutes
before you continue processing.
Overheat protection
This appliance is equipped with overheat protection. If the appliance overheats, it switches off auto-
matically. Unplug the appliance and let it cool down for 5 minutes. Then put the mains plug back into
the wall socket and switch on the appliance again. Please contact your Beper dealer or an authori-
sed Beper service centre if the overheat protection is activated too often.
8