Publicité
Les langues disponibles
Les langues disponibles
EH
A
1
A. EH clamp
2
Bolt clamp in desired position.
3
Provide adequate spacing of adjacent clamps to enable opening for conduit
installation.
The specifications and instructions for our customers in this document
reflect the product engineering level at the time of manufacturing. Please
consider the valid data sheet release at a time. For questions please contact
the PMA customer service. PMA AG accepts no liability for damages resulting
from unprofessional installation or application or misuse for a purpose. This
dis claimer also includes damages to third parties. It is the cus tomer's
responsibility to check the delivered products and immediately notify PMA
AG of detected faults. It is also the customer's res ponsibility to test the
PMA AG (Headquarters) · Aathalstrasse 90 · 8610 Uster · Switzerland · Tel: +41 44 905 61 11 · Fax +41 44 905 61 22 · pma-ch.info@tnb.com · www.pma.ch
B
B.
Conduit
EPS
A
1
A. EPS clamp
The EPS clamps can be mounted on standard metal C rails or directly on a
plate.
The mounting possibilities shown below for a C rail with rail nuts also apply
for plate mounting.
2a
Attach clamp with center bolt. A
pin can be used if necessary to
prevent the clamp from twisting.
3a
Insert conduit in clamp, snap clamp
cover closed.
(Optional: use additional screws if
necessary to hold closed.)
delivered product on its applicability for the intended purpose. PMA AG
will accept no liability or responsibility for their products if a product or a
PMA system is combined or used together with third-party products, i.e.
products from other companies than PMA AG. Jurisdiction in all legal disputes
concerning product liability have the courts of the canton of Zurich/
Switzerland. Swiss law applies.
For more information and the latest data sheet releases go to: www.pma.ch
B
B.
Conduit
2b
Preattach clamp with center bolt.
3b
Insert conduit in clamp, snap cover
closed, anchor on sides with bolts
or threaded rod for heavy loads.
Publicité
