Evenflo FlexLite Instructions page 5

USING YOUR STROLLER
2
B
3
C
D
D
4
E
E
F
6
*
Some models feature swivel locks that improve handling over
rough ground.
To keep front wheels from swiveling, pull up on the swivel
lock levers B . Push down the swivel locks to restore the
swivel action.
To open the child's tray , pull a locking tab on either
C D
side of the tray.
You can open the tray from either side.
C
To remove the tray C , pull
both tabs and remove the tray
from the stroller.
WARNING
DO NOT raise or recline seat with
child in stroller.
To recline seat, press the strap release button on the
adjuster E and allow seat to recline.
To raise the seat, hold the D-ring , then press the
F
release button and slide the adjuster E toward the
seat.
5A
5-pt Harness
H
H
G
G
K
L
L
J
Step 2
I
H
H
I
Step 1
3-pt Harness
K
L
L
J
M
USING YOUR STROLLER
WARNING
waist restraint.
sides are locked by lifting up the
rear of the stroller using the parent's handle.
Lock the rear brakes and pivot the child's tray out of the way.
With the 5-point harness, the harness shoulder straps G must start at
shoulder height or lower and use the harness strap buttonholes H clos-
est to the baby's shoulders, as shown. To adjust the height of the har-
ness straps to the baby's shoulder height, do the following:
1. On the back of the stroller, insert each harness shoulder strap buckle
I through the corresponding buttonhole H in the seat back, as
shown, and push it through to the front side of the seat back.
2. On the front of the stroller, insert each harness shoulder strap buckle
I from Step 1 through the corresponding buttonhole H at the
desired height location in the seat back, as shown, and push it
through to the back side of the seat.
Place the baby in the seat and bring the crotch panel J up between
the child's legs. Fasten each buckle K. For a snug, comfortable fit,
pull the shoulder straps G to tighten the shoulder restraint (shoulder
restraint only for 5-point harness) and pull the waist restraint straps L
to tighten the waist restraint.
L
buckle and pull.
Once the child is properly restrained, close and lock the child's tray.
sure the tray locks into position with audible clicks. Pull on the child's
tray to make sure it is locked into place.
Remove each harness shoulder strap G from each buckle K, as
shown. Remove both shoulder straps
from the stroller seat back. Store
G
shoulder straps for future use.
K
ALWAYS use
M on the
Make
7