Care And Cleaning - Toastess TB-50GS Mode D'emploi

TB-50GS_Book V002
• To crush ice, place the ice cubes into the Jar with the motor switched off.
Close the Lid and turn the Speed Control to the Pulse setting. Add a little
water through the Filler Cap opening for more even ice crushing.
• DO NOT operate the Blender for more than 90 seconds when processing
dry ingredients.
• DO NOT run the Blender when empty

CARE AND CLEANING

1. Unplug from wall outlet.
2. Remove Blender Jar from Blender Base. Wipe the Blender Base with
a damp cloth. If necessary, you can use a little mild detergent.
DO NOT IMMERSE IN WATER OR ANY OTHER LIQUID.
3. Empty the Blender Jar completely. Rinse the inside with water, then
remove the black plastic Jar Base and Cutting Blade Assembly by turning
the Jar Base counterclockwise.
4. Remove the Cutting Blades and gasket. NOTE: Be careful when handling
the Cutting Blade Assembly, the blades are sharp.
5. Wash the Blender Jar, Lid, Filler Cap, Jar Base, Gasket and Cutting Blades
in warm soapy water. Rinse and dry.
6. To reassemble, place the Gasket on the bottom of the Blender Jar.
Fit the Cutting Blades through the hole in the Blender Jar. Place the
black plastic Jar Base over the bottom of the Jar and turn clockwise.
8/5/04 4:38 PM Page 14
5