Check Temperatur And Pressures - CTR CLT 1 Manuel De Service

pag
56
SeTTING ON CLT1
mAxImUm
mINImUm
it is to be noted that the tolerances are a result from the thermal loads of the ambient. between
the minimum and maximum values the compressor must to be regulated in stages. The changes
on low pressure side should be similar to the change of the settings on the CLT1.
To prevent storing error in vehicle electronics, use the simulator . Connect it with the free
connection.
The simulation box simply contact with the free plug of vehicle electronics.
for that use the universal pins on the simulations box.
The polarity is with the simulation box without relevance. for vehicles with only one line you con-
nect the second line of the simulation box with ground (31).
USER MANUAL CLt1 REF 4018400

CheCk TemPeRATUR AND PReSSUReS

LOw PReSSURe
1,6 +/- 0,5 bar
3 +/- 0,7 bar
OUTLeT TemP.
0°C +/- 3°
10°C +/-3°