Pole Assembly - T-Fal IS5200 Mode D'emploi

1800121329 IS5200 T-FAL_105x148,5 25/10/10 08:45 Page21
Description
1. Steam head
a. On/off and Steam Set button
2. Hook
3. Flexible fabric hose
4. Pole locking ring
5. Removable water tank
6. Telescopic pole
7. Rotating hanger
Garment steamer assembly

Pole assembly

1. Place the base on the floor and put in the water tank -
2. Insert the telescopic pole into the base and turn the locking ring to secure it
into place - fig 2a, 2b.
3. Fit the hook onto the top of the pole until you hear a click sound -
4. Insert the hanger into the 2 holes located at the back side of the hook and pull
it down to secure it -
5. Place the steam head on the hook.
This garment steamer is equipped with rotary hangers in order to store the
steamer easily. To turn the hangers
1. Gently pull the hanger (a) to free it from the notch located at the back of the
hook (b) - fig.5.
2. Turn the hanger to set it horizontally or to store it vertically -
3. Fit parts (a) and (b) together in the desired position -
The dual clip system is adjustable in height in order to be perfectly adapted to the
different garment lengths.
Fabric brush assembly
• Insert the fabric brush into the holes located on the
steam head - fig.9.
• Before removing the fabric brush, be sure the
appliance is unplugged and totally cool.
• Pull the brush out of the steam head to remove it.
TIP : Before using this accessory, check the
manufacturer
fig.4a, 4b.
Functioning of the rotary hangers
recommendations.
8. Dual clip system for pants
a. Higher part to hang
b. Lower part to tighten
9. Fabric brush
10. Power indicator light
11. Clips for pole fastening
12. Power cord clips
fig.1.
fig.8.
Be sure unit is
unplugged and
completely cool before
attaching this
accessory.
It is also
21
fig.3.
fig.6 et 7.