Namiba Terra Biostat 1000 Instructions page 10

3.Program light level
press 'Mode' Button and hold it over 3 seconds,
when symbol is flashing, press 'Set' buttons to
adjust the volume you want.
Select range:
From 0 to 9, each press is 1 level.
0 to 9 is from light to dark
(level 0 means a little bit
dark computer will see it as night, level 9 means the computer will see it as night
only it is complete dark without any lights)
4.Program the day/night humidity difference
press 'Mode' Button and hold it for 3 seconds,
when symbol is flashing, press 'Mode' button
again till symbol is flashing, then press 'Set'
button to adjust the volume you want.
Select range:
From -20% to +20%, each press will be 1%
(eg. If you chose -20%, the night humidity will be
20% lower than day time humidity setting. If you chose +20%, the night humidity will
be 20% higher than day time setting.)
5. Program the alarm
press 'Mode' Button and hold it for 3 seconds,
when symbol is flashing, press 'Mode' button
again till symbol is flashing, then press 'Set'
button to adjust the volume you want.
Select range:
From 0% to 20%, each press will be 1%
(0% meaes no alarm function)
Manufacturer pre-set
Relative humidity:
Light sensor level:
Day/night difference:
Alarm:
75%
0
0%
0%
(eg. Level 3 light level)
(eg. -15% day/night difference)
(eg. 10% alarm setting)