Troubleshooting Guide - Taurus 912800 Mode D'emploi

and then dry. CAUTION! Do not immerse electrical
parts of the appliance in any liquid.
4.4. Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive products, for
cleaning the appliance.
4.5. Never submerge the appliance in water or any
other liquid or place it under running water.
5. Anomalies and repair
5.1. Take the appliance to an authorised support
centre if product is damaged or other problems
arise.
5.2. If the connection to the mains has been dam-
aged, it must be replaced and you should proceed as
you would in the case of damage.

6. Troubleshooting guide

No.
1
2
3
4
6.2. Abnormal conditions:
If the machine experiences an abnormal condition, it
will automatically stop and turn into standby mode.
An Error code will display on the LCD screen.
Problem
Switch not working
LCD shows E01
LCD show E02
LCD show E03
26
27
Overflow of the heating blending jar:
The spillage sensor is there for when the liquid
in the blender is too much. When the machine
experiences an overflow, the machine will enter
standby mode.
Remove some liquid and clean the spillage sensor
before continuing.
Note: soup in the heating blender jar cannot exceed
cold state 1600ml hot state 1250ml.
When the LCD displays 'E02' it indicates the lid is
properly secured on the blender
Reason
The appliance is not
powered on.
The appliance fails to
start
Too much liquid in the jug
blender
There is some food on
the spillage sensor.
There is not enough liquid
in the jug.
The jug blender cover is
not correctly fitted.
Attachments incorrectly
assembled.
Solution
Check your connection to
the power supply.
Press the power switch
Reduce the amount of
liquid
Clean the food off the
spillage sensor
Add more liquid
Ensure the jug blender lid
is properly fitted.
Assemble attachments
according to user manual.