Samsung DW50T6060 Serie Mode D'emploi page 19

1 in.
(24 mm)
Sink
Min. 30 in.
(762 mm)
Min. 20 in.
Drain
(508 mm)
hose
CAUTION
• Use caution not to damage the drain hose when installing the dishwasher.
• Install the drain system properly so that the drain hose does not disconnect from the
drain outlet in the draining process.
• Make sure that the drain hose, supply hose, or power cord is not kinked or folded.
DW50T6060US_AA_DD81-03056A-00_EN.indd 19
1. Check the size of the sink's drain hose
If the drain hose does not fit into the sink
connector, you can purchase an adaptor at
5/8 in.
3/4 in.
(15 mm)
a plumbing/hardware store.
(18 mm)
2. Slide the hose clamp to the end of the
Drain Hose requires a high loop if there is
no air gap, make sure to hang the middle of
the drain hose well above the sink cabinet
base to prevent back-flow (See the image
on the left side).
3. When drilling a hole for the drain hose
Dishwasher
4. Secure the drain hose to the sink wall
connector. If needed, cut the drain hose
so its end fits into the sink connector.
NOTE
hose, insert the drain hose into the sink
connector, and then tighten the hose
clamp.
NOTE
on the cabinet wall, use caution not to
damage the drain hose on the sharp
edges of the hole.
- On wooden walls, use sand paper to
soften the edges.
- On metal walls, use insulation tape or
duct tape to cover the sharp edges
around the hole.
using cable ties or other fastening
materials.
English English 19
2020-05-14 오후 6:09:09