Huffy LED Manuel Du Propriétaire page 8

LIGHT BARS & BATTERIES
(If Equipped)
Light Bars:
• The light bars have motion
sensors on them; they will
light when the unit is in use,
and stop after the unit is still.
• Put the switch
position (on the underside of
the unit) to activate the light
bars.
Note: Some models do not have
switches.
On these models, initial activa-
tion of the light bar is through
removing the battery protection
pull-tab
Battery:
DC 1.5V, AG13 (included). Each light bar has 2 batteries.
Battery replacement:
• Remove the screws from the light bar cover - remove the cover
• Remove the batteries from the circuit board
• Install new batteries with the + side facing you.
• Check the operation by moving the scooter to activate the motion sensor.
• Replace the light bar covers & secure them with the screws.
WARNINGS:
Non-rechargeable batteries are not to be recharged.
• Different types of batteries or new and used batteries are not to be mixed.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the unit.
• Keep the circuit board from getting wet.
• The supply terminals are not to be short-circuited.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
WARNING: Dispose of batteries properly. Do not dispose of batteries in fire, bat-
teries may explode or leak. Check local regulations for proper battery disposal.
8
A
in the ON
A
B
C
.
C B
.