Technical Data - Hanhart Modul 3 Manuel D'instructions

Technical Data

Temperature range
in use: -15° C to +55° C
in storage: -25° C to +65° C
Battery
Type: Mignon cell AA
Lifetime: app. 2 - 3 years
Indicator: Symbol in the display, 1 week warning
Display
LCD, 1,5-lines, 7/2 digit, clock, memory note,
various symbols
Modul 3:
Accord 1:
Case
ABS-plastic, 85 x 62 x 27 mm
Weight
95g with battery
Accuracy
+/- 14 sec. / month
Measuring units
Modul 3:
Accord 1:
Storages
60
Options
Interface connector for Modul 3
reset all
h
reset
memory
9
h - mm - ss
99999,99
1/100 sec.
1/100 min.
start stop
set
min sek 1/100
SPLIT
set
mode display
Battery replacement
Remove the battery cover by pressing grove located on
the bottom of the case (see diagram). Load battery as
per diagram inside battery compartment with correct
polarity (+/-). Replace cover. After the battery has been
replaced, the date and time must be reset once again.
Installation of lanyard and protection pouch
Remove the battery cover, pull lanyard through one of
the holes from the outside of the case, and then pull out through the
other hole from the inside of the case. Pass through with both ends of
the lanyard into the holes of the protection pouch from the inside and
tie it together.
Possible functions Modul 3 / Accord 1
a) Reset, return memory and display to zero
b) Time measurement
c) Memory recall / memory reset
d) Clocktime
e) Date
a) Reset, return memory and display to zero
Reset Stopwatch by simultaneously pressing the START/STOP key and
MEMORY key at the same time. All recorded times and memories will
be reset. However, the previously selected modes will remain the
same.
b) Time measurement
A short press of the MODE key pages through the functions.
The rotation sequence is Split, Lap, Addition (not with the ACCORD),
Time and Date.
With the START/STOP key, the time will be measured, displayed and
placed in memory. After each Start/Stop operation, the time will be
displayed (frozen). This indicates the time measurement, the display
is standing still, however the internal clock is still active. To see the
running time, press the DISPLAY key again.
10