Filling The Tank - Wirbel SW1 450M ECO Utilisation Et Entretien

EN

7.1 FILLING THE TANK

(Fig. 10
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
- Remove the hose (1) supplied, connect
one end (1a) to a tap and insert the other
end (1b) in the tank (2).
- Turn on the tap and fill the tank (2).
- The tank's water level is indicated by the
red ball in the transparent tube (3).
- Pour the liquid detergent into the tank.
N.B.:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
DANGER:
If the detergent comes in contact with the
eyes and/or skin or if swallowed, refer to
the use and safety information booklet
provided by the manufacturer of the de-
tergent.
- When finished filling the tank:
Insert the tube (1) completely into the
tank (2). The end of the tube (1a) acts as
a cap.
)
1b
EN-14
3
1a
1
2
Fig. 10