MO-EL 315 Emploi Et Entretien page 7

8.Do not bring modifications to the product that compromise the
safety.
9.Keep connections dry.
10.If the power supply cord is damaged avoid to use it. Let the
Manufacturer, or the After Sale Service, or some similar qualified
person replace it, in order to avoid any risk.
11.Disconnect the appliance from the supply line, if you don't use it
for a long time.
12.Always unplug the appliance before doing any maintenance op-
eration.
13.Periodically verify the integrity of the appliance. If defects are
found, do not use it; call an Authorized After Sale Service.
14.In case of malfunction or fault, call an Authorized After Sale
Service, and request original spare parts.
MOUNTING AND SETTING
This appliance is intended for indoor use only.
The hand dryer has been specifically designed for vertical at-
tachment on the wall with the air outlet toward the bottom.
An overvoltage category III bipolar circuit breaker, with contact
opening distance of at least 3 mm must be fitted upstream
from the supply line.
Make sure that the wall where you plan to mount the appli-
ance is solid and free of electrical cables or water pipes inside.
For safety reasons, never attach the device near bath tubs,
wash basins, showers, or other fittings where there may be
water.
This hand dryer must be installed out of the range of a person
using the bath or the shower.
1.Apply the drilling template on the wall using adhesive tape and
punch in the points marked.
2.Drill holes in the wall using a 9 mm bit in the 5 points indicated.
3.Loosen the three Allen screws that attach the body to the base,
then remove the body.
4.Hookup:
7