Product Operation - Marshalltown Bullet MS90-1913 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Note: Every 1" of width requires approximately 40lb (18kg) on the handle. (e.g. a 4" wide plank requires 160lb

(72kg) to cut, 5" wide plank requires 200lb (90kg) to cut.)

The Magnum Edge Hardwood Shear is operated manually. The two-part extendable handle is grasped by the

operator and pushed down to make a cut.

1. To unlock, gently press handle down, slide Bullet

Cam-Lock (A) in and down.

2. Place Material (B) on table, and slide under blade to

desired cut position.

3. Push handle (C) down until material is completely cut.

The blade should be set so it cuts into the plastic blade stop (D)

when the handle is pressed down.

To set the blade depth, rotate the two large nuts (E) on the

underside of the base with a 11/2" (38mm) wrench.

Ensure that both are turned an equal amount.

Adjust in 1/4 turn increments and check to see how deep the blade is set.

To open the blade to cut 1" material, loosen the Back Stop Knob (F)

and rotate the Back Stop (G) up.

Please note: Approved materials may vary in density

and hardness. If extreme pressure is required to cut

a product, it may result in damage to your machine.

Please contact MARSHALLTOWN before proceeding.

Warranty is void if an unapproved product damages

the machine.

Firmly lift the friction-fit fence to remove it from the table and press back down in the appropriate 45-degree position.

NOTE: This image is for the Marksman. Your shear may look slightly different.

WS2637

104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com