Paslode WCS200 Manuel D'utilisation page 6

TOOL OPERATION
Successive (Bounce) Driving (Orange
Trigger)
Grasp the handle firmly.
Squeeze the trigger and move the tool along the work-
piece with a bouncing motion, depressing the work
contacting element at the points where you want to drive
a fastener.
Keep the trigger depressed and continue to bounce the
work contacing element against the workpiece, position-
ing the tool above as carefully as possible.
When the desired number of fasteners have been driven,
release the tool trigger to avoid unintentional fastener
discharge.
Unload Staples:
To unload staples, simply pull the follower to the rear of
the magazine to it's locked position., the magazine cover
will open automatically. Slide the staples to the rear of the
magazine and lift the staple strip from the rail.
6