Table des Matières
Publicité
15
of 4 ° C to 40 ° C. A new battery or one that has not been used for a long time acquires its full
capacity after about 5 charging and discharging cycles.
The grid voltage must correspond to that indicated on the charger plate.
Before starting charging, always check the charger status and the power cord first.
To charge the battery, only the charger supplied with the battery drill should be used.
The charger must not be subjected to rain, moisture or liquid pouring.
WARNING: Place the battery pack and charger on a flat, non-combustible surface and away
from flammable materials when recharging the battery.
1. Insert the charger plug into the socket.
2. Connect the battery to the charger cable.
The rechargeable battery should not be charged for more than 1.5 hours. The charging station
will turn off automatically after the battery is fully charged. The power supply must be switched
off before removing the battery from the charging station. Avoid short-lasting charges one after
the other. The rechargeable battery should not be charged after a short use of the cordless drill.
During charging, both the charger and the battery are warming up. This is quite normal. The
significant reduction in the time between the individual charges indicates that the battery is worn
out and needs to be replaced.
3. While charging the battery, the red light, yellow light, and green turn on alternately. When only
the red light is on, the battery is insufficiently powered. When the red and yellow lights are on,
the battery is half charged. When all three red, yellow, and green indicators are on, the battery
is fully charged.
4. Mobile phone charging function:
Plug the USB plug of the charging cable into the USB connector of the battery depending on
the port / jack.
5. Work with the cordless drill. Settings, on and off.
5.1. Switch on - Press the start button (1).
5.2. Shutdown - releases the start button (1).
5.3. Spindle Brake.
Publicité
Table des Matières
