Chauvet DJ Gobo Zoom USB Manuel De Référence page 4

Gobo Zoom USB QRG
AC Power
Power Linking
Fuse
Replacement
IRC-6
(Infrared
Remote
Control)
Mounting
Mounting
Diagram
Control Panel
Description
WARNING! DO NOT plug anything other than a D-Fi USB into the USB
port. Doing so may cause damage to the product.
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
For the maximum number of Gobo Zoom USB that can be power linked at
120 V or at 230 V, see the User Manual or the label on the product.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
Before mounting this product, read the
Clamp
(such as the CLP-15N
from Chauvet)
Mounting Bracket
IR Sensor
Button Function
Exits from the current menu or function
<MENU>
Navigates upwards through the menu list and increases the
<UP>
numeric value when in a function
Navigates downwards through the menu list and decreases the
<DOWN>
numeric value when in a function
Enables the currently displayed menu or sets the currently
<ENTER>
selected value into the selected function
Safety Notes.
4
EN
Safety Cable
(such as CH-05
from Chauvet)