Assembly; Wall Mount Installation - IRIS IC-SB1U Serie Mode D'emploi

ASSEMBLY

When assembling or storing, lay the vacuum sideways to avoid it falling over . When completely assembled, vacuum can be
stored upright using the wall mount .
Main body
Extension pipe
Main body
Collection head
Collection head
HAND-HELD:
COMPLETE ASSEMBLY
COLLECTION HEAD
Line up the triangles (Δ) Collection head can be
on the collection head and attached directly to the
extension pipe and press main body without using
together firmly . the extension pipe .
Line up the triangles (Δ)
on the extension pipe
and main body and press
together firmly .
Brush
HAND-HELD:
TO DISASSEMBLE
BRUSH ONLY
Main body can be used on Please pay attention to
its own by pulling down the surroundings and use
brush head . caution when removing
the collection head and
extension pipe in order to
avoid hitting anything .
5

WALL MOUNT INSTALLATION

Does not stick well in low temperatures . Installation should be done in areas with a temperature of
50°F/10°C or higher .
May damage or change color of certain surfaces, such as paint or varnished plywood .
CAUTION
Adhesive may not stick well to certain surfaces, such as wallpaper . In this case, use screws to
attach wall mount to the wall .
Original adhesive sheet cannot be reused if moving the wall mount . Please use a spare adhesive
sheet or double sided tape found in retail stores to reattach .
The cord hook on the back of the main body has a built-in magnet, allowing you to store the unit by placing it against the iron
plate of the wall mount . Unit can also be stored by leaning it against the wall .
Using the Adhesive Sheet
1 If using the adhesive sheet, wipe off dust, oil, and moisture from the
surface the adhesive sheet will be placed on . Please do not use
chemical cleaning products to wipe the wall .
2 Peel the paper off the back of the wall mount and press it firmly into
place . See Mounting Height directions for ideal placement .
*It will take approximately 24 hours for the glue on the adhesive sheet
to set . Do not mount the vacuum until the adhesive glue is fully set .
MATERIALS
Polypropylene, polyethylene, soft rubber .
On wallpaper, textured wall, dry wall, easily
peeled paint, walls treated with fluorine or
silicone, etc .
Uneven surfaces
LOCATIONS
Areas of high heat and humidity
Areas that moisture can easily permeate
Outdoors
Wall seams and the surrounding areas
How to Remove Adhesive Sheet
1 If screws were used to install the wall mount, remove them .
2 Slide a thread in the gap between the mount and the wall . Move
the thread left and right, then pull off the wall mount . There will still be
adhesive residue .
3 Place a damp cloth or paper towel over the residue . Please hold in
place for about 10 seconds .
4 Please remove the damp cloth and lightly wipe away the remaining
residue with a dry cloth .
Adhesive sheet
on the back
Wall mount parts
Mounting Height
Screw
hole
height
38-38.5in / 96-97.5cm
6