Electrical Connection - Trailfx W08B Manuel D'utilisateur

Electrical connection

For normal self-recovery work, your existing electrical system is adequate. A fully charged battery
and proper connections are essential. Run the vehicle engine during winching operation to keep
battery charged.
Pay close attention to proper electrical cable connection as follows:
W08B, W10B, and W12B
1. Short red cable (B') connecting to the red terminal (B) of the motor.
2. Short black cable with yellow jacket (C') connecting to the yellow terminal (C) of the motor.
3. Short black cable with black jacket (D') connecting to the black terminal (D) of the motor.
4. Thin black cable (A ') connecting to bottom terminal (A) of the motor.
5. Long black cable (1.8m), one terminal (A') connecting to the bottom ternimal (A) of the motor
and the other terminal negative (-) connecting to the negative (-) terminal of battery.
6. Long red cable positive (+) connecting to positive (+) terminal of battery.
WS10B
1. Short red cable from Winch connecting to the Positive (+) terminal of the battery.
2. Short black cable (supplied separately with the Winch) one end connecting to the
Winch Terminal A & the other to the Negative (-) terminal of the battery
Remote control operation (for WS10B):
1. Plug the control cable (with the remote hand controller attached) into the socket on the control
box and turn slightly counter-clockwise to lock into position.
2. It is recommended that for the initial set-up of the winch (prior to applying any load)
that the winch be operated in the Wired mode.
3. Once the winch has been set-up then the remote hand control can be operated either in
the Wired or Wireless mode.
4. To use the remote hand controller in the Wireless mode unplug the remote hand controller
from the control cable.
5. The hand control is not waterproof and care must be taken in its usage.
Remote battery changing instructions:
1. Remove the screws & dismantle remote cover.
2. Remove the CR2 3V 900 mAh battery (Blue Color) & replace with a new one. This battery is not
related to the remote operation & needs to be changed only when the LED light is not working.
3. For changing remote operation battery, remove the "In & Out Switch" from PCBA by pulling it
upwards.
4. Slightly bend the small PCBA located above A23 12V battery (Golden Color) for easy access and
replace with a new one.
5. Bend the same PCBA back to its original position & fix "In & Out Switch".
6. Fix the remote cover back in to its position & assemble with the screws.
7. Please use only the designated size batteries mentioned above.
Note
1. Your battery must be kept in good condition.
2. Be sure battery cables are not drawn tight across any surfaces, which could possibly damage them.
3. Corrosion on electrical connections will reduce performance or may cause a short.
4. Clean all connections especially in remote control switch and receptacle.
5. In salty environments use a silicone sealer to protect from corrosion.
6. Index the heads of the plate studs into the keyhole slots on the back of the winch.
If electrical cables are closer to hot surface, use the heat protection sleeve as
required to prevent damage.
9