Replacing Cord Cover - Neptune Peerless-AV ODTV4901 Manuel De L'utilisateur

Replacing Cord Cover

1. Run cables across foam gasket block. Leave approximately 1/2" (13mm) between cables to
ensure a proper seal.
2. Replace cord cover plate and (4) thumb screws (C). Fasten thumb screws until gasket on cord
cover plate is fully compressed to back of television. Cables will seal between TV's gasket and
cord cover's gasket as cover is pressed into place. Route cables through opening at end of cord
cover.
Failure to follow these instructions can result in the product being damaged,
destroyed, and voiding the warranty.
C (4)
• Ensure cord bend radius does not exceed limits set by the
manufacturer.
• Ensure cords are seated properly in the cable channels to avoid
potential damage to cords when rear cover plate is installed.
• Do not remove lanyard that connects the rear cover plate to the display.
CAUTION
CAUTION
10
Do not overtighten screws
2017-02-17 #:180-9117-4 (2019-04-02)