Preparation And Set Up - OTC 1595A Mode D'emploi Et Liste Des Pièces

Outil de levage pour groupe motopropulseur

Masquer les pouces Voir aussi pour 1595A:

Instructions d'utilisation (7 pages)

Table Des Matières

Table des Matières

Les langues disponibles

Parts List & Operating Instructions

Unpackaging

1. Cut shipping banding from carton and platform.

2. Remove the wood chocks from around the caster wheels.

3. Carefully roll the Power Train Lift off the shipping pallet onto the floor.

Prepare The Air Pump For Operation

A. Pictogram Definitions

B. Cut shipping tie straps from air pump.

C. Air Supply Hook Up

1. Remove the thread protector from the air inlet of the pump. The pump's air inlet is 1/4-18 NPT

internal threads. Select and install the threaded fittings which are compatible with your air supply

fittings. The air supply should be 20 CFM (.57 M³/min.) at 100 PSI (7 BAR) at the pump to obtain

the rated hydraulic pressure. Air pressure should be regulated to between 50 PSI (3.5 BAR) and

140 PSI (9.5 BAR). A pressure of 100 PSI (7 BAR) is the recommended minimum. Secure your

pump fitting to the air supply.

2. It is highly recommended to install an automatic air line oiler to the air supply as close to the pump

as possible. Set the unit to feed approximately one drop of oil per minute into the system. Use SAE

grade oil, 5W to 30W.

D. Priming The Pump Unit

Under certain circumstances it may be necessary to prime the air pump.

To accomplish this, perform the following procedure:

1. Press the release end of the pedal while holding down

the air intake valve with a flathead screwdriver. The air

intake valve is located directly under the pedal in the area

marked

with the

2. Allow the pump to cycle approximately 15 seconds.

3. Remove the screwdriver and press the

pedal once more.

4. If the cylinder extends or pressure builds, the pump has

been successfully primed. If the pump does not respond,

repeat the procedure, jogging the air intake valve while

holding the pedal in the